Water hookup for refrigerator How to Install a Water Line for a Refrigerator Ice Maker

Water hookup for refrigerator

Let us guide you through the process.

Free online dating sites for mobile phones

The manual made no reference to this. Requires basic plumbing skills, including soldering.

Polyamory married and dating episodes

By subscribing, you agree to the privacy policy and terms of service. Running a water line to a refrigerator to supply its ice maker and drinking water dispenser has never been easier.

Required Tools for this Project

Here is how to tap into the cold water pipe and get cold water to your refrigerator ice maker and water dispenser: Coil the excess water line behind the refrigerator.

Shut off the water at the valve that controls the cold-water supply pipe to the faucet.

Indian dating girl

Because it has attracted low-quality or spam answers that had to be removed, posting an answer now requires 10 reputation on this site the association bonus does not count.

Connect the Supply Tube to the Refrigerator.

Plumb the fridge

His work has been featured in national publications like "Parents" and "U. The story and how-to photos cover tapping into an existing water pipe the toughest part of the job and attaching copper tubing to the fridge.

Gay men dating sites

If you need to drill through floors or walls, check for air ducts, electrical hookup website canada, plumbing or other possible impediments first.

Shut off the water supply. Adapt-a-Tees can be used in hookup blast reviews situations where you need an extra line.

Polyamory married and dating episodes

For water dispensing, pressing in a lever results in water traveling through your water lines to your refrigerator and coming out in a controlled stream until the same lever is depressed.

Here's how it works: If not, you will need to run a line to the nearest cold water pipe, which is probably in the floor below your kitchen.

Drill/driver fitted with 5/8-inch spade bit

That being said, if your refrigerator doesn't have an ice maker or water dispenser, or if it has one or both of these but you prefer not to use them, you don't need to connect the refrigerator to a water line.

To straighten coiled tubing not the hookup for rollhave a partner hold the end of the refrigerator flat on the floor, then push the roll against the floor while unrolling to the length you need to go water the cabinets.

Pentecostal dating service

You should have cold water very shortly. Then slide on the compression fittings, lubricate the threads on the refrigerator fitting with pipe compound and screw on the tubing.

The longer answer is that it varies from model to model.

Tapping the Cold Water Line

First, find the cold water source nearest the refrigerator-it could be under the kitchen sink, below the floor, in the wall or even in the ceiling.

Some people told me a couple of hours was water hookup for refrigerator, but others have told me up to 12 hours.

Australian matchmaking sites

If you have a water dispenser on your fridge, dispense about a gallon of water and spill it down the kitchen sink drain. Also, check for leaks where the supply tube connects to the refrigerator before pushing the appliance back into place.

It takes patience, but you can hook a water line up to your refrigerator on your own.

Cynthia Gomez

Drill a quarter-inch hole into the water pipe and attach a shut-off valve to the pipe using a clamp and packing nut to create a watertight seal. Is this really still a problem? Get the latest This Old House news, updates and special offers every week, direct to your inbox. When laid on its side, the oil in the compressor goes up into the refrigerant lines.